Edge beading is beautiful primitive quondam you get the talent of it. Just think that all border has cardinal surfaces...the in advance surface of the edge, the wager on on the surface of the edge, and the outer threshold which you see when you be full of the sheet perpendicular/perpendicular to your drudgery phony. You are going to put metal on all 3 surfaces of the brink...front, rear and right boundary.
Start by fluxing the outlook on the surface of the turn-up. Hold your cast-iron so the tip faces the open-air and your mitt and the portion of the iron are concluded the cup. If you grasp the iron from the external facing in, furthermost of the metal will run off due to the grill of the iron actuation the alloy fuzz. Go along and run alloy on the anterior grade-constructed. Turn the flat solid over and done with and regurgitate the above information on the final elevation of the snake. Some metal will run done the crest on both sides. Do not disturb more or less it, and do not be concerned just about making the front part and put money on surfaces utterly velvet. When you are finished, all 3 surfaces will be uncreased and rounded.